Tool bit grinding gauges, South Bend repro & NEW Brass cutting gauge!

Description: Tool bit grinding gauge#GG-01 & GG-02 (NEW for brass!)ONLY $12.99 each! “A-LEE-SAM” We have faithfully* reproduced the grinding gauge used to check a tool’s side and front clearance and tool cutting angle! Made from 16ga Stainless steel, (*thicker than the original to last a lifetime)! For about 1/10 the price of an original SBL specimen selling on Ebay, you can have a heavier duty model with all the same functions! Comes with simple instructions with diagrams. Every machinist’s chest should have one! Not just for South Bend lathe owners! Any home shop machinist, gunsmith, steam or gas / locomotive / train model maker using any lathe. ORIGINAL SBL GAGE SEEN IN PIC IS NOT INCLUDED!NOW, a new tool bit grinding gauge is available for cutting BRASS! Our GG-02 is designed using the most common specs for grinding your tool bit for turning BRASS material on your lathe. Same 16ga Stainless steel construction as our GG-01. *Some have questioned the different appearance of the angles between the original South bend Lathe gauge and our GG-01. The angles are exactly the same on both. We used a larger triangular cutout* on our reproduction, (same angles), to give the cutting point of the tool more room. The SBL's gage was originally stamped and we found that where the triangular cutout intersects the little circle was sometimes pinched too tight or left a burr not allowing the tool to register properly. SEE OUR REPRODUCTION OF SBL'S TOOL BIT GRINDING JIG! GRIND PERFECT ANGLES ON YOUR TOOL BITS. HOLDERS AVAILABLE FOR MOST 3/16, 1/4, 5/16, 3/8 & 1/2 INCH SQUARE TOOL BITS.

Price: 12.99 USD

Location: Lima, New York

End Time: 2024-01-04T00:07:17.000Z

Shipping Cost: 5 USD