Resin 3D Printer Flex Building Plate,Spring Steel Flexible Plate and Magnetic...

Description: 224x129mm resin 3D printer magnetic build plate for ELEGOO Saturn,Saturn 2 8K Saturn 2 8K,Saturn 8K,Saturn 3,Saturn 3 Ultra; Installation Details: 1. Please clean your printing platform completely and let it dry. 2. Please connect the magnet to the board, and after it is fitted, leave it for a few hours (more than 24 hours is better) to make it completely fixed. 3. Please install the spring steel plate on the magnetic base 4. Please reset the printer’s leveling settings to start printing How to use: 1) When installing the soft magnetic sheet, you need to ensure that the printing platform is clean and dry. After installation, it is best to keep it in an inverted state, or it can be fixed with a clip to ensure that the soft magnetic sheet is completely attached to the printing platform. 2) Please ensure that the spring steel is completely aligned with the magnetic base to avoid resin entering the gap during use, affecting the magnetic force of the soft magnet and causing the spring steel to fall off. 3) If there are burrs on the surface of the spring steel, please polish it carefully with sandpaper before use to ensure that there are no burrs to prevent the burrs on the spring steel from piercing the FEP film during the printing process. 4) After printing, do not bend the spring steel excessively when disassembling the model. After use, use alcohol or cleaning fluid to remove residual resin from the surface. 5) After using it for a period of time, if the model falls off the spring steel sheet during the printing process, you can use sandpaper to polish the spring steel sheet to ensure that it has sufficient adhesion. Packing list: 1 piece of spring steel construction plate + 1 piece of soft magnetic sheet Applicable model: 224x129mm is made for ELEGOO Saturn 4,Saturn 3, Saturn 4 ultra,Saturn 3 Ultra,Saturn 2 8K,Saturn 8K, Saturn.This resin magnetic flexible steel plate flex bed is also can used for the plate 's size which is longth between 224-234 mm,the width between 129-139mm. High durability:Flexible steel plate with high chromium content, easy to bend and clean. Much easier to remove prints and avoid damages during the process, especially for small prints. Good corrossion resistance and prevent rust. Brushed surface provides better adhesion, ensure a perfect print. At the same time, after installing the magnetic printing platform, you will need to re-leveling the 3D printer for excellent printing results. Easy to operate: Traditional DLP light-curing printer platforms must use tools to disassemble, while this resin flexible board can be disassembled by bending. Easier removal of printed models from the resin build surface. Makes it easier to remove prints and avoid damage in the process, especially for small prints. Clever design: The magnetic printing platform is equipped with a handle that makes it easy to install and remove the magnetic printing platform. Installation method: Thoroughly clean and dry the printing platform plate, attach the magnet to the printing platform plate and let it sit for a while to fully seat it, install the spring steel plate on the magnetic base again, and finally reset and level the printer. Set to start printing. It is recommended to print (A4) 3.8mm thick spacers to facilitate the normal zeroing of the Z axis.

Price: 28.51 USD

Location: Brentwood, New York

End Time: 2024-09-19T15:17:16.000Z

Shipping Cost: 0 USD