Description: This CNC machined, and fully polished stainless steel(NO RUST!) component is a great way to vent your 9" Ford rearend. (Or most any other rear axle for that matter). Simple, effective, and great looking. It has a 7/16-20 mounting thread. Just drill (.4375), tap (7/16-20), and insert! NO MORE HOSES! There is NOTHING out there cooler! IN STOCK for immediate shipping! This is the same vent I used on my "Spirit of '47" 5W coupe!(as shown) I LOVE it! You will too! Please note the second photo. It shows two holes. One in the center, and one in the head. The rear end will vent up through the hole in the middle, and then out through the hole in the head. Notice also that the threads stop, and will not allow the vent to bottom out on the rear axle tube, allowing a gap for the escaping air to exit the rear axle. As far as tightening, that's what the two machined flats on the head are for. It allows for a 1/2" open end wrench to tighten. Also note, it is a 7/16-20 thread, so it probably won't simply replace any stock vent the rear end may already have. You will have to drill a hole to the correct size (not 7/16, but .4375), and tap (7/16-20) as the listing states. Hot Rodders, Thank You for your support! - John Docktorthe 32partsguy! Returns – Buyer is responsible for return shipping.
Price: 24.95 USD
Location: Bedford, Texas
End Time: 2024-09-17T03:24:00.000Z
Shipping Cost: 3.95 USD
Product Images
Item Specifics
Returns Accepted: ReturnsNotAccepted
OE Spec or Performance/Custom: Performance/Custom
Brand: PRO-BILT HOT ROD PARTS
Other Part Number: 300902
Item Diameter (Interior): 3/4"
Manufacturer Part Number: 2232
Surface Finish: POLISHED STAINLESS STEEL
Item Length: 1"
Bore Diameter: 7/16" - 20
Placement on Vehicle: Rear
