MUD-SKIPPER® Long Tail Mud Motor Kit 8-16hp - 2 Pc Shaft With 15HP ENGINE

Description: The Mud-Skipper 8-16HP Long Tail Motor Drive System Including 15HP Engine The long tail shaft separates into two pieces making transport easier and makes shipping to you less expensive at the same time! The Kit Includes: 2 Piece - 100 Long Solid Steel Driveshaft with Sealed Roller Bearings and Oil Seal Entire mud motor powder coated HAMMER TONE grey The kit is designed for 8hp to 16hp motors by using a 1 PTO shaft (see list of some of the compatible motors below) PTO Housing Features Hardened Steel Coupler and pre-installed key PTO Housing, PTO Shaft and Long Tail Shaft are one piece - eliminating multiple assembly steps Redesigned Transom Mount with Hardened Bolts and Cups - Locks at 5 different points Engine Mount Base - with Grade 5 Bolts and nuts Transom Pivot Bearing Multiple Grease Points Z Style Adjustable Tiller Handle - Right and Left Hand Steering Option 8.5 Diameter Stainless Propeller Stainless Steel Throttle Cable & Cantilevered Brake Style Aluminum Throttle Control Lever Push Button & Tethered Safety Kill Switch Overall Length 147 Tiller Length 42 - (Tiller is 2 piece) Weighs 59lbs (Before adding engine weight) No Welding or Fabrication - requires only basic hand tools! This long tail kit is designed for sneak boats, canoes, layout boats, jon boats etc. Newly Designed Transom Mount - Grade 8 Hex Bolts & Cups Transom Mount is 4 Deep and 2.75 Wide The Engine Mount The four bolt holes fit most engine bases up to 16hp The tiller handle attaches to either side. Multiple engine balance settings. The PTO Shaft Connector The PTO Housing fits over the engines crankshaft. PTO housing, PTO shaft and long tail are all connected, eliminating multiple assembly steps! The Drive Housing The housing is bolted over the engines drive shaft (crankshaft) All 8hp to 16hp engines have the four bolt hole configuration. This kit utilizes a 5 Bolt Circle The Throttle Linkage Connections Engine Requirements 1 Keyed, Horizontal Drive Shaft with 5 Bolt Circle (Holes 3.5 x 3.5 in a square) Engine Mounting Bolt Holes - 3.75 x 7.6875 Kill Switch Installation Limited Two Year Warranty: If, within TWO years from the date of purchase your longtail mud-motor kit fails due to a defect in materials, or workmanship, we will repair or replace, at our discretion, any part that we determine to be defective in materials or workmanship, free of charge. If the product fails, the buyer must contact Mud-Skipper for an RMA prior to returning the product. Failed parts must be returned for inspection. Shipping expenses for any item submitted for repair or replacement under this warranty are the responsibility of the owner of the item. Mud-Skipper will provide return shipping of the repaired or replaced part to the customer via UPS, USPS parcel post, or other freight carrier of our choice (additional charges for expedited return shipping to the buyer is the responsibility of the buyer). This warranty does not cover damage due to impact, normal wear, excessive wear to the shaft or shaft bushings due to lack of lubrication, neglect, corrosion, lack of maintenance, modification to the product, or misuse. The customer will be responsible for the shipping costs of any item returned to them that is not covered under warranty. This warranty is provided to the original purchaser. Proof of original purchase is required on all warranties, exchanges, and returns. Electrical parts ARE covered under this warranty. Propellers ARE NOT covered under this warranty.

Price: 825 USD

Location: Lyons, New York

End Time: 2024-11-30T16:34:19.000Z

Shipping Cost: 100 USD