MagCAD Garmin Varia Specialized Tarmac SL8 Seat Post Clamp Mount

Description: Features:MagCAD Garmin Varia mount for the Specialized Tarmac SL8.Clamps to your Specialized Tarmac SL8 seat post.Compatible with Garmin Varia radar lights up to the RTL515/516 but NOT the RCT715 camera/radar light. Weighs just 16 grams without hardware.The Garmin Varia and seat post are pictured for reference only and not included. What's Included1x 3D printed mount.1x M4x30mm cap screw.1x M4 dome Nyloc nut.OverviewThis mount has been a popular request, now available as really clean and secure solution for mounting your Garmin Varia to your Specialized Tarmac SL8 seat post. This design replaces the OEM Varia mount with rubber bands which would always tend to move or rotated whilst out riding. This mount is compatible with both the 15mm and 0mm offset Tarmac SL8 seat posts. Please note the Garmin interface on the Varia devices is the same as the Garmin Edge devices but rotated 90 degrees. Therefore if you mount a Garmin Edge cycle computer to this mount it may not be the correct orientation for your setup. Please be aware, this MagCAD mount is compatible with Garmin Varia radar lights up to the RTL515/516. It is NOT compatible with the new Varia RCT715 radar/camera. ApplicationThis MagCAD mount will be 3D printed and supplied fully assembled with stainless steel fasteners.Remove the M4 screw, supplied, and separate the two 3D printed components.Slot the horseshoe shaped component over the front of the seat post, noting the correct upward position and preventing the M4 Nyloc nut from falling out.Locate the Varia mount at the back of your seat post and re-install the M4 screw, loosely tightening.When assembled correctly the Varia interface should be vertical to the ground.Position up or down your Tarmac SL8 seat post to suit and tighten the M4 screw to 1Nm with a 3mm Allen key.Install your Garmin Varia device in the normal quarter turn motion.All fasteners should be checked periodically to ensure they are still tight. Compatible With:Garmin Varia devices up to RTL515/516.Not compatible with the Varia RCT715 radar/camera.Specialized Tarmac SL8 (15mm and 0mm) seat posts.MaterialMagCAD Mounts are 3D printed in Nylon PA12. However these are not your typical home 3D printers. Following a process of SLS (Selective Laser Sintering) on industrial size printers, costing anything above £100k, the resulting mounts have fantastic resolution and refinement. The surface finish is slightly rough with a matte effect and the performance of the mounts are comparable to injection moulded parts. Customisation As with all MagCAD items it's more than possible to tweak or change the design to suit your particular installation. Feel free to get in contact for more details. About Me I’m a MEng Aerospace Engineer and former professional cyclist. All the items, including this mount, are ones which I’ve developed and use myself. A hobby which I take too far but want to share with others. DeliveryAll items in stock and dispatched promptly, usually the same day. ReturnsShould you have any issue or just change your mind we're happy to accept returns within 30 days, providing the item is unused.

Price: 24.99 GBP

Location: Leek

End Time: 2024-10-06T09:53:24.000Z

Shipping Cost: 18.48 GBP